wartuta.blogg.se - Acronis os selector

Reboot the computer and never defragment that partition.

Run the installation once again in Custom mode and choose the created small partition as the installation path.

Remember that you should choose the appropriate operating system to boot after the uninstallation (the operating system under which Acronis Disk Director is installed)

Run the Acronis OS Selector installation program ( Start -> Programs -> Acronis -> Acronis Disk Director -> Install Acronis OS Selector), uninstall it and reboot.

It does not matter if the partition is created at the beginning of the drive or not

Create a small (but not less than 10 MB) FAT/FAT32/NTFS partition on the hard drive.

To avoid the issue in future it is recommended to create a dedicated partition for Acronis OS Selector: It is a very simple installation with a reboot.

Reactivate or completely disable Acronis OS Selector using Acronis OS Selector Bootable Rescue Disk. The first thing that needs to be done after the suite is installed is to install the Acronis OS Selector. during a defragmentation session), then Acronis OS Selector will fail to load. (!) If the physical location of these files on the hard drive changes (e.g. Acronis OS Selector records the absolute address of the following configuration files in the MBR: FAT The most probable cause is that the partition on which Acronis OS Selector was installed has been defragmented. If the error message is MBR Error 3, then the last booted operating system starts. or with an endless loop of error messages. What the issue may be related to and how to overcome it SymptomsĪcronis OS Selector fails to load with Starting Acronis Loader.